C&C 35 – 3 35ft

Bayfield, ON, CA

C&C 35 – 3 35ft

SOLD

Bayfield, ON, CA

Sold

About

FRESH WATER YACHT

This vessel has undergone an extensive refurbishing and is 98% of the way though thisproject.

The following will give you an idea of current condition

A) General description

This 1985 C&C 35 Mk3 has the C&C smoke white gel coated hull and deck.
She has a painted navy blue cove stripe with matching twin navy blue waterline stripes.
The waterline stripes have been raised so that they do not get fouled.

There is a factory original C&C designed wing keel installed with 1 inch diameter stainless steel keel bolts through oversize backing plates in a generous bilge giving the boat a draft of 5 feet 6 inches. The wing keel was installed with West System Epoxy and 3M fairing compounds.
The bottom was coated with Interlux VC17 Epoxy Tar and VC17m paint when new and has been maintained with the VC17 products.

The port and starboard cockpit drain thru hull's were repositioned higher in order to drain above the waterline.

The original Yanmar 3GMF diesel engine drives a MaxProp Classic 2 bladed feathering propeller.

The engine heat exchanger heats the water in the stainless steel 110VAC hot water tank.

The mast, boom and radar mast are painted with white Pettit EASYPOXY paint.

There is an Edson stainless steel wheel and pedestal.

A spinnaker pole and associated gear are present.

A Hood roller furling system is fitted for the 110% jib.

Down below, the boat has the factory installed teak trim option on the sides of the V-berth, the sides of the main salon and the side of the quarter berth.

The factory curtain package is also installed.

There are port and starboard water tanks. The galley and head are serviced with pressure hot and cold water.

A manual marine head with holding tank forward is installed.

There is a shore power 110 VAC system for powering the battery charger, hot water tank, microwave and HVAC heat pump.

On the transom is a stainless steel with wood tread boarding ladder and a pair of stainless steel davits.

B) The following upgrades have previously been added on deck

1)A new, 2023, Lewmar 12 Vdc horizontal windlass installed on a shelf mount in the anchor locker.

2) Double stainless steel anchor rollers on the bow with with integral forestay chain plate.

3) Plow type Kingston 35 lb. main anchor with 103 feet of 5/16 3B windlass chain rode.

4) Secondary genuine Bruce 22 lb. anchor with 25 feet of 3/8 chain and 150 feet of nylon double braid rode.

5) Chain locker sea water wash down hose.

6) A full depth, fiber glassed, water tight, anchor chain locker built into the lower half of the anchor locker.

7) Anchor chain locker manual bilge pump.

8) Removable adjustable light genoa sail forestay and halyard.

9) Stainless steel, staysail stay, fore deck chain plate bolted to the anchor locker bulkhead.

10) Removable adjustable heavy genoa sail/staysail stay and halyard.

11) Port and Starboard spinnaker pole topping lifts .

12) Stainless steel rigid adjustable vang.

13) Two additional Barient 18 winches on the mast,

14) Two additional Barient 18 winches on the cabin top at the foot of the mast.

15) Additional line stoppers for lines led aft.

16) Stern mounted white painted aluminum radar mast with gimbaled radar platform.

17) Stainless steel davits.

18) Cockpit cushions - 2 inch closed cell foam with zippered vinyl covers. Port, starboard and helm seats

C) Sails

1) Doyle Boston Dacron mainsail with two reefs and full battens (new).

2) Doyle Boston Dacron 110% jib on the Hood roller furling system (light use).

3) North red / white / blue 3/4 oz. symmetrical spinnaker

4) North mylar laminate 150% hanked on genoa to go on the heavy removable genoa / staysail forestay.

5) Hood nylon red / white / blue hanked on MPS asymmetrical to go on the light removable genoa forestay ( light use).

6) Doyle Boston Dacron 85% hanked on staysail to go on the heavy removable foredeck genoa / staysail stay ( light use).

D) The following upgrades have previously been added below deck to the boat.

1) The ice box has had additional insulation added to it on all sides and a 12 Vdc refrigeration unit has beenadded

2) The galley / engine box has been reconfigured and is now removable so the the engine can be fully accessed for service.

3) The galley is serviced with pressure hot and cold water and manual hand pumps for the fresh water tanks and sea / lake water.

4) Built in microwave oven in the galley area.

5) Dometec Marine Air Systems 110 Vac 10,000 BTU Compact HVAC reverse cycle Heat Pump unit installed in the main cabin port seat locker.

6) All of the cushions have just been reupholstered with a sand/beige coloured microfiber fabric (new).

7) The manual toilet in the head has a 1 1/2 seacock installed to prevent back flow from the forward holding tank.

8) The sink drain in the head has a 12 VDC pump that is connected to an anti siphon manifold to prevent prevent back flooding.

9) The shower sump in the head has a 12 VDC pump that is connected to an anti siphon manifold to prevent prevent back flooding.

10) The 12 VDC automatic bilge pump is connected to an anti siphon manifold to prevent prevent back flooding.

11) The low area in the bilge under the Nav / Galley area cabin sole has been filled with fiberglass and resin.

12) The hollow bilge area under the mast step has been filled with lead shot and resin and glassed over.

E) Electronics

1) Two Garmin 6212 chart plotters.

2) Garmin 24 inch radar dome.

3) Datamarine speed, depth, apparent wind and wind speed.

4) Raymarine Type 1 below deck autopilot installed on the steering quadrant (new).

5) Raytheon VHF radio.

F) Additional items

1) A heavy duty steel cradle with hull bunks is included for winter storage or vessel transport.

2) There are dodger and bimini bows / frames which are not currently mounted on the boat. There is no canvas for these frames. If the purchaser wishes to add a dodger and bimini, in their choice of design and colors after the purchase, the bows / frames will be included with the purchase of the boat.

3) The loose items package includes winch handles, snatch blocks, jib sheets, spinnaker sheets, fenders, dock lines and manuals.

G) 2023 / 2024 General refit upgrades and renewals - work in progress or completed

1) A new Lewmar 12 Vdc horizontal windlass installed on a shelf mount in the anchor locker.

2) A new replacement anchor chain locker manual bilge pump installed.

3) The small 12 Vdc electric bilge pump and float switch servicing the HVAC has been replaced with new.

4) The Henderson cockpit mounted manual bilge pump has been rebuilt and remounted.

5) A new Raymarine Type 1 below deck autopilot installed with a new (NOS) Raymarine 7001 controller.

6) New windows with aluminum frames installed in the cabin trunk sides.

7) New acrylic installed in the fore cabin's deck hatch.

8) New acrylic installed in the head's deck hatch.

9) New acrylic installed in the main cabin's deck hatch.

10) New acrylic installed in the companionway hatch.

11) Upgraded battery system with three batteries under the 1/4 berth.

12) Routine replacement of various hoses.

13) New galley manual hand pumps for the fresh water tanks and sea / lake water.

14) New pressure pump for the hot and cold fresh water system.

15) New pressure pump for the sea / lake water anchor locker deck wash system.

16) New 110VAC shore power cord.

17) A fresh coat of VC17m blue antifouling paint.

Safety Gear

This 1985 C&C 35 Mk3 will have the following safety items aboard and are included with the purchase of the boat.

  1. Transport Canada approved life jackets - quantity of 4 adult jackets.
  2. Buoyant heaving line - 15 meters long.
  3. Lifebuoy attached to the buoyant heaving line.
  4. Stainless steel with wood tread stainless steel stern mounted boarding ladder.
  5. Thirty five pound Kingston plow anchor with 103 feet of 5/16th 3B chain and 10 feet of 5/8 three strand nylon rode.
  6. Twenty two pound genuine Bruce anchor with 25 feet of 3/8th chain and 150 feet of 1/2 inch double braid nylon rode.
  7. Cockpit mounted manual bilge pump.
  8. Electric 12vdc bilge pump.
  9. Bucket.
  10. Flare package - quantity of 12 type A, B, C or D flares [not more than 6x type D flares).
  11. Water tight flashlight.
  12. Radar reflector for hoisting on the aft mounted radar mast or one the main mast flag halyards.
  13. Sound signaling device.
  14. Class 10BC fire extinguisher - quantity of two.
  15. Binnacle mounted Danforth Constellation compass.
  16. Full set of all required navigation lights.

Survey(s)

1) In August of 2023 a hull and deck survey reported that the coring is dry with no issues.

2) In the spring of 2024 when the current general refit is completed, a full survey will be completed and available.

 

Testimonials

George Ayers was terrific to work with over the past few months as I evaluated, negotiated and purchased a CS 30 that Harris & Ellis Yachts had listed in Sarnia. He was patient, thorough and totally professional. I have owned nine sailboats in my 50+ years as a sailor. My experience with George and Harris & Ellis Yachts has been my best boat buying experience to date.

George did an amazing job of selling our CS 30 sailboat. A caring and compassionate person, he went above and beyond our expectations and never stopped working on our behalf to get the job done. We are forever grateful for his dedication to his work. Please let him know how much we think of him!

I am writing to express my deepest gratitude for the outstanding service provided by Greg. Last October, my husband suddenly passed away due to a heart attack, leaving behind two boats. Greg was instrumental in helping me sell the first boat quickly and at a very good price. As for the second boat, due to my husband's declining health in his final year, the boat had been sitting idle at the dock near our home for over a year. Greg demonstrated the utmost professionalism in cleaning, maintaining, and preparing the boat for sale. He put in a tremendous amount of work, understanding the niche market for this boat, and always kept me informed of his progress without burdening me with the stress of the process. Last week, Greg successfully sold the second boat, and I am very satisfied with the price achieved. His professionalism and confidence in his work gave me a much-needed sense of security during such a difficult time.    

Thank you for all your work in facilitating the sale of our dad's boat. Jake and I really appreciate all the hard work you put into it with the many visits, paperwork, etc. A special mention has to go out to Grant for teaching me how to fold the sails!

As first-time boat buyers and as foreigners wanting to buy a cruising catamaran in the US, we knew we needed a reliable broker that had our best interests in mind. John Heintzman was just that, and more! He was extremely committed to understanding what we were looking for, gave great advice, and guided us through the purchase process with great patience and knowledge. All in all, we felt very well taken care of.

I feel compelled to reach out about the absolutely wonderful experience that I have had with Grant and Patricia Bowlby. I completed the purchase of a boat yesterday and I couldn’t be happier. They were so helpful, kind, and patient. This was my first experience with a broker, and I think I’ve found the best.

I can’t thank Ewan Campbell enough for the super job he did in selling G, making up for my lack of experience in this realm and patiently searching for just the right buyer and a win-win for seller and buyer alike.

It was a wonderful experience selling A with Jeff Cole’s expert assistance. Thank you for simplifying a complicated process. Your patience and kindness are especially appreciated.

I just wanted to thank Jeff Cole for all his hard work. He was very professional and effective.

Our Latest from Instagram

This error message is only visible to WordPress admins
Error: Invalid Feed ID.